4/23/2021 0 Comments Bladez Xtr 450 Manual
I have gone through all the troubleshooting I can find on the web and believe the problem is the control board.The problem is that when flip the switch on you get the green light but the scooter will not go when you pull the throttle.Actually its hard to describe but the motor kind of skips sometimes when you turn it on but then quits after a few seconds.If you short across the throttle the motor starts doing its skip thing like its pulling against the chain and letting go in quick succession.
These boards run 90 new and I am wondering if there is a cheaper viable solution or someway to fix the control board I have. I have an EBlades 450 watt scooter that I burned out the controller in. Rather than replace the controller with the OEM part I extended and widened the frame to allow for a third battery and turned all three batteries sideways (rotated them 90 degrees) and used a schwinn 750 watt 36 volt controller and throttle, onoff switch and charger port and the thing FLIES and is very reliable. I never tested it with a car speedo but I would guess 22-23 mph. They are notorius for going bad and overcharging the batteries. Is there any problem with buying parts from electricscooterparts. Bladez Xtr 450 Upgrade Where DidI like it what parts did you get for your upgrade Where did you get them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |